B Pillar Instructions

Remove the old pillar wraps and adhesive before fitting. This can be tricky and is best to use a heat gun and tar and glue remover. Make sure the surface is completely free of any dirt or glue and is clean and dry. Using rubbing alcohol or degreaser is advised!

Peel the pillar wrap off the backing paper and line up the holes at the bottom of the pillar. Lightly stick the pillar wrap down so you can peel and adjust as necessary! When you are happy with the final placement apply firm pressure all over the vinyl preferably with a squeegee - the air release vinyl will allow you to remove air bubbles easily!